MF18 – 3.06 Installation, Operation & Maintenance Instructions Annealing Ovens TLD models This manual is for the guidance of operators o
TLD 10 MF18 – 3.06 7.0 CIRCUIT DIAGRAMS 7.1 Single Phase coil Instrument Switch temperature controller SSR e l
TLD MF18 – 3.06 11 8.0 FUSES & POWER SETTINGS 8.1 Fuses F1-F2: Refer to the circuit diagrams. F1 Internal supply fuses Fitted if suppl
Carbolite, Parsons Lane, Hope, Hope Valley, S33 6RB, England. Telephone: +44 (0)1433 620011 Fax: +44 (0)1433 621198 E-mail: [email protected] The p
TLD 2 MF18 – 3.06 1.0 SYMBOLS & WARNINGS 1.1 Switches and Lights 1.2 Warning Symbols 1.3 Introduction Reproducible
TLD MF18 – 3.06 3 2.0 INSTALLATION 2.1 Unpacking & Handling Lift the unit by its base. Do not use the door or any other projecting cover o
TLD 4 MF18 – 3.06 3.0 OPERATING INSTRUCTIONS 3.1 Operating Program The program consists of the stages shown in the graph below. The rates of
TLD MF18 – 3.06 5 To turn the oven off, set the Instrument switch to it’s off position; the controller display will go blank. If the oven is to
TLD 6 MF18 – 3.06 4.0 MAINTENANCE 4.1 General Maintenance No routine maintenance is required other than the occasional replacement of consumab
TLD MF18 – 3.06 7 5.0 REPAIRS & REPLACEMENTS 5.1 Safety Warning – Disconnection from Supply Always ensure that the oven is disconnected fr
TLD 8 MF18 – 3.06 5.6 Thermocouple Replacement Remove the front panel and the internal cover as necessary. Make a note of the thermocouple co
TLD MF18 – 3.06 9 6.0 FAULT ANALYSIS A. Oven Does Not Heat Up 1. The temperature controller is OFF No power from the supply Check the fuse
Kommentare zu diesen Handbüchern